The show command – USRobotics NETServer/8 User Manual
Page 145
Administrative Tools 9-11
The SHOW command
The show command can be used to view the NETServer’s
current configuration and its routing activity. The command has
the following options:
show...
all
all S-ports
arp
IP address resolution data
filter
a specific packet filter
flash
a summary of flash memory
global
global configuration
init_script
a modem initialization string
ipxroutes
the ipxroutes table
location
a location table entry
memory
DRAM memory usage
netconns
Active connections
net0
LAN port configuration
netstat
network statistics
netuser
the specified user
routes or routing
the IP routes table
sap
SAP interfaces
s
the specified port
sessions
current dial in sessions
table filter
filter table summary
table hosts
hosts table summary
table location
location table summary
table netmask
the netmasks table
table snmp
snmp table summary
table user
user table summary
uptime
time since the last reboot
user
the specified user
The commands in this list that are related to viewing specific
tables are discussed in the sections of Chapter 10 relevant to the
information being shown. Show filter is discussed in Chapter 8.
The show commands used mostly for troubleshooting are
covered below. They include: Show arp, flash, memory, netconns,
netstat, sap, and sessions.