USRobotics NETServer/8 - Manual (Page 34)

3-4 Configuration Overview
Save your changes
You can save all of your changes, or you can save changes to a
specific table only.
Note: We recommend using save all. If you save tables
individually, the space used by the previous version of the table
is not freed up. Issuing the save all command frees up any
unused space before saving.
save all save all configuration data
save s save a port’s configuration
save filter save all of the packet filters
save global save the global table
save host save the hosts table
save ipxroute save the IPX routes table
save location save the location table
save netmask save the netmask table
save routes save the IP routes table
save snmp save SNMP configuration
save user save the User Table
Reset any ports you have changed
If you make changes to any port, you must reset the port before
the changes take effect. This will close any active connections on
the port!!!
reset all S-ports (s0 through s16)
reset s a specific S-port
reset n an active connection
(find handle with show netconns)
Reboot when necessary
The only changes that require rebooting the NETServer are
changing its LAN port (Net0) configuration. If you change the
Net0 configuration, save your work and then type the following
command:
reboot
How to log out of the command line
When you are done configuring the NETServer, you may exit
the command line interface by typing done, exit, or quit.