USRobotics NETServer/8 - Manual (Page 133)

Packet Filters 8-19
Editing Packet Filters
Edit a Packet Filter
See Filter Rule Format, earlier in the chapter for a description of
filter rule format. For information on filter rule options, see the
section specific to the type of packet filter you are editing.
To edit a filter, replace an existing rule with a new one. Use one
of the following commands:
set filter < permit | deny>
set ipxfilter < permit | deny>
set sapfilter < permit | deny>
When you are finished, save the filter with the following com-
mand:
save filters
Delete a Packet Filter Rule
To delete a rule, use the following command:
set filter
set ipxfilter
set sapfilter
To delete all rules of a certain type, use the following command:
set < filter | ipxfilter | sapfilter> blank
Delete a Packet Filter
To delete a specific packet filter, use the following command:
delete filter
Save a Filter
Save your changes by issuing the following command:
save filters