USRobotics NETServer/8 - Manual (Page 212)

10-62 Command Reference
Network User Parameters
Dialback
This is the location that the NETServer will dial after verifying
the user’s name and password. It must be a valid location in the
Location Table. Use the following command:
set user dialback
IP Address
This is the IP address that the user has for the duration of the
connection. Use the following command:
set user address < assigned | negotiated | IP address>
Assigned You may select this option only if you have speci-
fied an IP address block in the Assigned Address
field of Global Configuration. The NETServer
assigns the remote user a temporary IP address
from this block of addresses.
Negotiated This option is valid for PPP connections only. The
NETServer attempts to learn the IP address of the
remote computer.
IP Address The IP address of the user’s computer must be
entered.
IPX Network
To the networks on either end of a dial connection, the virtual
link between the NETServer and the remote device will appear
to be a physical network segment. This is a unique IPX network
number assigned to that virtual network segment. It must be
unique in both the NETServer’s local network and any network
attached to the dial in user. Use the following command:
set user ipxnet