Ipx remote access – USRobotics NETServer/8 User Manual
Page 73
Network Dial In Access 5-15
IPX Remote Access
This case study assumes the following:
•
The configuration will take place from the Command Line
software.
•
The NETServer is configured with the correct IPX network
number, IPX Frame Type, and Sysname.
•
The NETServer is set to the factory defaults on all other
settings.
•
Two users want access to a Novell server on the
NETServer’s network (userA and userB).
IPX Remote Access Case Study
Configure the ports
Ports 3 and 4 will be used for this application. Set them both to
network dialin.
set s3 network dialin
set s4 network dialin
After connecting to either port, the user will receive a welcome
message. Use the following command:
set s3 message Welcome to the Computer Center
set s4 message Welcome to the Computer Center