View an individual port, 34 command reference – USRobotics NETServer/8 User Manual
Page 184
10-34 Command Reference
View an Individual Port
To view a specific port, use the following command:
show s
The information that appears may look something like this:
Status:
Command
Parity Errors:
0
Input:
964
Framing Errors:
0
Output:
17606
Overrun Errors:
0
Pending:
0
Active Configuration
Default Configuration
(* = host
—————————————
———————————
can override)
Port Type:
User Login
User Login
Login Service:
NetData
PortMux
Baud Rates:
115200
115200, 115200, 115200
Databits:
8
8
Stop bits:
1
1
Parity:
None
None
Flow Control:
None
None*
Modem Control:
Off
Off
Init Script:
USR_int
Init When?:
Every Reset
Hosts:
Erie
Default
Terminal Type:
Login Prompt:
$hostname login
Dial Group:
0
Extended Parameter Display
The NETServer can display information in either a basic or an
extended mode. The extended parameters are miscellaneous
parameters such as the Terminal Type, Host Override setting,
and Autolog name. By default, display of the extended param-
eters is enabled for all ports.
For more concise information summaries, you can disable
extended parameter display using the following command:
set s
To enable extended parameter display, use the following
command:
set s