Unisys E-@CTION EFP9800 - Manual (Page 180)

Ithaca Peripherals Proprinter Emulation Commands
7–12 3255 4073–002
Set 10 Characters/Inch
Sets the character size to 10 characters/inch. You can change character size in
the middle of a line.
To double the width from 10 characters/inch to 5 characters/inch, use the Set
Single Line Double-Wide (0E) command. To return to single-wide characters,
use the Cancel Single Line Double-Wide (14) command.
Hexadecimal Decimal ASCII
12 18 DC2
Cancel Single Line Double-Wide
Only cancels double-wide characters set by the Set Single Line Double-Wide
command (0E). This command will not cancel double-wide characters set with
the Set Double-Wide command (1B 57 31).
You can change the character size in the middle of a line.
Hexadecimal Decimal ASCII
14 20 DC4
Cancel Underlining
Stops underlining.
Hexadecimal Decimal ASCII
1B 2D 30 27 68 48 ESC - 0