Unisys E-@CTION EFP9800 - Manual (Page 100)

EFP9800 ESC/POS Commands
6– 10 3255 4073– 002
Select Print Mode(s) (for Windows™ Printer Drivers)
Selects the print mode(s) specified by the value of n as outlined below. The
default is 1. This command is intended for use with Windows printer drivers
developed with the Windows unitool. This command is nearly identical to Select
Print Mode(s) (1B 21) except that the bits for Double-Strike and Underline are
ignored.
Hexadecimal Decimal ASCII
1B 22 n 27 34 n ESC “ n
Value of n in Hexadecimal
Print Mode 33/35/42 Characters
per Line (5 x 9) 40/42/51 Characters
per Line (7 x 7)
Standard 00 01
Double-High 10 11
Double-Wide 20 21
Double-High and Double-Wide 30 31
Note: Underlines cannot be printed for 90 degree clockwise rotated
characters or for spaces set by the Horizontal Tab, Set Absolute
Starting Position, or Set Relative Print Position commands.
Note: In page mode, the 7 x 7 font (40/42/51 characters/line) cannot be
used.
Set Absolute Starting Position
Sets the print starting position from the beginning of the line, in the
fundamental calculation pitch. The distance (in inches) from the start of the line
is calculated as: [(n1 + n2 x 256) x (fundamental calculation pitch)]. See the Set
Fundamental Calculation Pitch command (1D 50).
Hexadecimal Decimal ASCII Value of n1 Value of n2
1B 24 n1 n2 27 36 n1 n2 ESC $ n1 n2 0-255 0-255