Toshiba E.STUDIO e-STUDIO 523 - Manual (Page 57)

55
2
5 Enter the 5-digit code again in the “Retype New Code” field using the
digital keys, and then press the [SET] button to set the entry.
• If you enter the code, asterisks (*) appear in the “Retype New Code” field.
• If you want to clear the code to retype it, press the [CLEAR] button on the Control Panel.
If you want to return to the “New Code” field to retype it, press the [RESET] button.
6 Press the [ENTER] button at the bottom of the touch panel.
• The LIMITATION screen is displayed.
7 Set the limitation of this department code as required.
• Press the [ON] button to enable the output limitation for this department code. When you select the [ON] but-
ton, enter the maximum number of the outputs for this department code to the “Limitation” field using the digital
keys. You can enter up to “99999999”. If you do not set the output limitation for outputs, press the [OFF] button.
• If you enter “0” for the limitation, it will disable printing any copies or prints using this department code.
• When the number of outputs exceeds the limitation during the job is being printed, few copies that exceeds the
limitation are printed and counted because the equipment cannot stop the job immediately.
8 Press the [ENTER] button.
• New department code is registered.