TANDBERG Gatekeeper/Border Controller API D14172.01 - Manual (Page 52)

TANDBERG Gatekeeper/Border Controller API User Guide
D14172.01 page 52 of 84
RegistrationSerialNumber:
The serial number of the registration to be removed.
SubZoneAdd
Adds and configures a new subzone.
SubZoneName(r):
Assigns a name to this subzone.
Address1:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength1: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address2:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength2: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address3:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength3: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address4:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength4: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
Address5:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a
subnet to be assigned to this subzone.
PrefixLength5: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP
Address to belong in this subzone.
TotalMode:
Determines whether this subzone has a limit on the total bandwidth of calls being used
by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to
Limited).
PerCallInterMode:
Determines whether there is a limit on the bandwidth for any one call to or from an
endpoint in this subzone.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this
subzone (applies only if Mode is set to Limited).