Toshiba E-STUDIO 210C - Manual (Page 98)

1
2
3
4
5
6
7
8
9
10
11
12
6-6
USING THE SPECIAL FUNCTIONS
3. BYPASS COPYING (Cont.)
1 Set sheets of paper on the bypass guide and align
the slides with the size of the paper.
- This message appears:
Ready for bypass copying
- The paper should be placed with the side to be copied
facing up.
- If the paper is long-sized, pull out the triple paper holder.
- Types of paper that can be used in bypass copying
Page 6-5
- If you put several sheets on the sheet bypass at a time, fan
the paper well before placing it.
2 Place the original(s). Page 2-9
Select other copy modes as required.
Slide
Bypass Copying
The general procedure for making bypass copies (the paper size is not specified) is described below.
3 Press the START key.