Toshiba E-STUDIO 210C - Manual (Page 132)

1
2
3
4
5
6
7
8
9
10
11
12
7-8
SELECTING FINISHING MODES (USING THE OPTIONAL FINISHERS)
2 Place the original(s). Page 2-9
3 Press the key on the basic screen as shown on the
right (shaded).
Number of punch holes and available paper sizes:
Since the number of punch holes and the distance between
the holes vary depending on the country, purchase a punching
unit that meets your requirements. (For details, consult your
service technician.)
4 Press the HOLE PUNCH key.
- If the key for the desired function is not shown, press the
Next key to switch the screen.
Select other copy modes as required.
5 Press the START key.
5. HOLE PUNCHING MODE
1 Place paper in the cassette(s). Page 2-4
- When using this mode in bypass copying ( Page 6-5), be
sure to specify the paper size.
With the optional punching unit attached to the optional finisher (MJ-1019, MJ-1020), you can have your
copies punched with holes.
* The paper weight should be in the range of 64 to 256 g/m
2 . Special paper such as OHP films or labels is
excluded.
Japan and most of
Europe (MJ-6002E)
North America
(MJ-6002N)
France
(MJ-6002F)
Sweden
(MJ-6002S)
Number of punch holes and hole diameter
2 holes
(6.5 mm dia.)
2/3 holes switchable
(8.0 mm dia.)
4 holes
(6.5 mm dia.; 80 mm pitch)
4 holes
(6.5 mm dia; 70, 21 mm pitch)
Available paper sizes
A3, A4, A4-R, B4, B5, B5-R,
FOLIO
2 holes: LG, LT-R
3 holes: LD, LT
A3, A4
A3, A4, A4-R, B4, B5, B5-R,
FOLIO