Toshiba E-STUDIO 210C - Manual (Page 165)

1
2
3
4
5
6
7
8
9
10
11
12
9-23
If test stapling fails to be performed and the following mes-
sage remains displayed, repeat the above procedure from steps
1 to 12.
Set staple cartridge
11 Confirm that the finisher is attached to the copier,
and that the paper size is set to any size other
than A5-R or B5-R.
- Test stapling cannot be performed when only A5-R or B5-R
paper is available.
12 Close the front cover of the finisher. Test stapling
is then automatically performed on a blank sheet.
- This operation is performed to avoid empty stapling.
Saddle Stitch Unit (MJ-1020 only)
1 Open the lower cover of the finisher.
10 Reinstall the stapler unit in its previous position and
turn the blue lever 90 o to the right to latch the sta-
pler unit.