Toshiba E-STUDIO 210C - Manual (Page 46)

1
2
3
4
5
6
7
8
9
10
11
12
3-2
SETTING OF BASIC COPY MODES
- If the Automatic Paper Selection mode is not selected, press
the ZOOM··· key, then press the APS key on the next
screen.
1 Place paper in the cassette(s). Page 2-4
- If the following messages are shown, proceed the indications
as you are told to:
Change direction of original
Set correct cassette
When the selected cassette size and the original size are the
same, the copier rotates the original data 90° and makes a copy
in the same size as the original even if those directions differ
(e.g. an A4-size original is set while the same size paper is set
in R direction). This function, however, is applicable to plain
paper only.
Select other copy modes as required.
4 Press the START key.
1. PAPER SELECTION
When you place regular-sized originals on the glass or in the reversing automatic document feeder
(optional), the built-in sensors automatically work to detect the size of the originals, helping the copier
select and copy on paper that is the same size as the original.
* Depending on the condition of the original, automatic paper selection may not work correctly. In that
case, select the paper size manually. Page 3-3
* This mode can only be used for actual-size (100%) copying.
* Original sizes capable of automatic detection
Page 2-9
Automatic Paper Selection (APS)
2 Place the original(s). Page 2-9
3 Confirm that the Automatic Paper Selection mode
(default setting) is selected on the basic screen.