Toshiba E-STUDIO 210C - Manual (Page 85)

1
2
3
4
5
6
7
8
9
10
11
12
5-15
Select other copy modes as required.
9 Press the START key.
6 Enter the distance values read in step 5 for the
specified area.
- Key in the value for X1 with the digital keys and press the
upper SET key.
- Similarly, set the values for X2, Y1 and Y2.
7 Press the lower SET key.
8 Place the original(s) on the glass face down and
with its bottom toward you and with its top left
aligned against the original scale on the left side.
Page 2-9
4 Place an original on the glass to specify the area.
- Set the original face up with the bottom toward you, fit its top
left corner against the top left corner of the glass, and align it
with the original scale.
5 Using the original scale on the left and the inner (top)
scale, read the position of the desired area as fol-
lows:
- X1 Distance from the top left to the left edge of the specified
area.
- X2 Distance from the top left to the right edge of the speci-
fied area.
- Y1 Distance from the top left to the upper edge of the speci-
fied area.
- Y2 Distance from the top left to the lower edge of the speci-
fied area.