TANDBERG ENTRYPOINT - Manual (Page 32)

D 14050.04
10.2007 32
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the
Entrypoint
Viewing the
System Status
Configuring
the Entrypoint
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
TANDBERG ENTRYPOINT
USER GUIDE
Configuring
the Entrypoint
TANDBERG ENTRYPOINT
USER GUIDE
IP Address Assignment is DHCP or Static:
DHCP: • Dynamic Host Configuration Protocol
can be selected when a DHCP server
is present. Static IP Address, Static IP
Subnet Mask and Static IP Gateway are
ignored because these parameters are
assigned by the DHCP server.
Static: • If Static assignment is used, the
Entrypoint’s IP address, IP subnet mask, and
the Gateway’s IP address must be specified
in the respective IP address fields.
Select IP from the
Configuration to access the
IP Configuration pane.
Save. When ready to store
the new settings, press
Save . These settings will
take effect when the system
has been restarted.
DNS Interface
Up to five Domain Name
Server IP addresses can be
specified here. Your LAN
administrator will provide
the correct values for these
fields. By default these fields
are set to
127.0.0.1
Date and Time Settings. An
NTP server address can be
specified here to provide the
Entrypoint with up-to-date
time and date information.
Restart. This button will
restart the Entrypoint.
Any changes made in the
IP Configuration of the
Entrypoint will take effect
after the system has been
restarted.
IP Configuration
IP Ethernet Speed provides five settings to
choose from:
Auto • The Gateway will negotiate detect the
speed and duplex on the LAN.
10Half • The Gateway will connect to the LAN
using 10 Mbps/Half Duplex.
10Full • The Gateway will connect to the LAN
using 10 Mbps/Full Duplex.
100Half • The Gateway will connect to the
LAN using 100 Mbps/Half Duplex.
100Full • The Gateway will connect to the
LAN using 100 Mbps/Full Duplex.
IP Address . The Static IP Address defines
the network address of the Entrypoint. This
address is only used in static mode. Your LAN
administrator will provide you with the correct
address for this field.
IP Subnet Mask . The Static IP Subnet Mask defines
the type of network. Your LAN administrator will
provide the correct value for this field.
IP Gateway . The Static Gateway IP address is
set to 127.0.0.1 by default. In case of a router
enter its address here. Your LAN administrator
will provide the correct value for this field.