Starting up the entrypoint – TANDBERG ENTRYPOINT User Manual
Page 17
D 14050.04
10.2007
17
TANDBERG
ENTRYPOINT
USER GUIDE
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the
Entrypoint
Viewing the
System Status
Configuring
the Entrypoint
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
Using the
Entrypoint
TANDBERG
ENTRYPOINT
USER GUIDE
To start the Entrypoint, simply connect the
power cable, and set the power switch button
(both at the rear) to position
I
.
On the front panel of the system the power
indicator LED, marked
PWR
, will turn
GREEN
.
Power switch
Accessing the Entrypoint
Forgot the Password?
The
pwrec
account is active for one minute following a restart.
Beyond that time, the system will have to be restarted to
change the password.
Entrypoint Start-up
Reboot the Entrypoint.
Connect to the Entrypoint via the serial interface once it has
restarted.
Login with User Name
pwrec.
No password is required.
You will be prompted for a new password.
Starting Up the Entrypoint
You may access the
Entrypoint by entering the
IP-address of the Entrypoint
in a standard WEB-browser.
You will then be asked to
enter a password. You will
need to enter
admin as
user name. The default
password for the Entrypoint
is
TANDBERG. Remember
that the password is case
sensitive. Note that you may
also use SSH and Telnet to
configure the Entrypoint.
USER NAME
is
admin
PASSWORD
. Default
password is
TANDBERG
(NB!
case sensitive)