TANDBERG ENTRYPOINT - Manual (Page 31)

D 14050.04
10.2007 31
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the
Entrypoint
Viewing the
System Status
Configuring
the Entrypoint
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
TANDBERG ENTRYPOINT
USER GUIDE
Configuring
the Entrypoint
TANDBERG ENTRYPOINT
USER GUIDE
Save. When all settings
are entered, click on Save
to make the new settings
become effective.
Outgoing Bearer capability. Within ISDN
different bearer capabilities are used to signal
the type of data (Voice, Data, H320, H.324M),
which is used by telephony switches and other
equipment to determine how to handle data
or calls (compressing voice data neglect etc).
The outgoing bearer capability sets the ISDN
bearer capability for the outgoing telephone
(voice only) and video telephone calls.
H.324M: This ITU standardized capability •
is selected for outgoing calls by default.
UDI: In some situations the switch does •
not accept calls which use the correct
H.324M capability. This setting makes it
possible to use the Entrypoint in these
situations via selecting UDI.
Select BRI to access the BRI
Configuration pane.
You cannot configure
ISDN BRI lines for
special functions like
dial out only! The Gateway
will automatically select a
free BRI line for H.323 to
3G calls and possibly block
a DiD or an IVR menu when
the BRI lines have different
numbers. Consequently, we
strongly recommend that
all ISDN BRI lines have the
same number range!
Contact your ISDN or
telecom supplier about
numbering plans of ISDN
lines.
BRI Protocol. Select between the following BRI
protocols:
ETSI (Euro ISDN) •
National ISDN •
AT&T Custom •
Japan/Taiwan ISDN •
ISDN/BRI Configuration (ISDN/BRI Versions only)
All incoming calls are accepted
independent of their bearer
capabilities, therefore audio calls are
accepted as well.