Toshiba TEC B-419-GS10-QQ - Manual (Page 36)

2. PRINTER SETUP EO1-33030
2.10 Program Download
2- 26
2.10.5 Printer Information
Registration
This procedure will be used to register (transfer) printer information to
the printer memory and the information registered here will also be
printed on every diagnostic print issued from the printer. The
information to be registered will be the printer model name and the
printer type.
•
Procedures
1. To perform this operation, you will need to turn on the power of the
B-419 printer (do not hold the feed key this time). Connect the
printer to the PC with the RS-232C cable. Select the TPCL-LE
mode for the printer issue mode. Then set the communications
parameters as follows:
19200 bps, None parity
2. From the Install Program for B-419 main menu, select Options (O)
and Printer Information Store (P) as shown in the screen display of
the figure below.
3. After selecting Printer Information Store (P), the screen will change
to the display shown below.
NOTE:
When the entire serial
number is entered, the printer
ID will appear automatically.
NOTE:
This information is stored in
printer memory before
delivery to the customer, so
this procedure need only be
done if it is required to
change any of the
information.