Toshiba TEC B-419-GS10-QQ - Manual (Page 17)

2. PRINTER SETUP EO1-33030
2.7 Loading the Media
2- 7
2.7.1 Loading the Fanfold
Paper
1. Place the fanfold paper at the rear of the printer in line.
2.
Place the paper top edge in front of the Media Inlet, and align the
left paper edge with the Paper Guide (L). Push the Paper Guide
Release Lever outside, and align the Paper Guide (R) with the right
paper edge.
3. Lock the Paper Guide by pulling the Paper Guide Release Lever up.
4. Turn the PC power ON, and then turn the printer power ON.
5. Insert the paper top edge into the Media Inlet until it stops. Pressing
the [FEED] button feeds one piece of the paper.
6. Send a print data from the PC.
7. The data is printed on the paper. Tear off the printed paper at the
edge of the Media Outlet.
NOTE:
Do not pull the printed paper.
Doing so may dislocate the
printer or misalign the print
position, causing a print
failure.
Media Inlet
Fanfold Paper
Container
NOTES:
1. Place the fanfold paper so
that the print surface faces
up and the top edge of the
paper is positioned at the
printer side.
2. Place the fanfold paper on
the surface below the
position of the printer’s
media inlet.
Paper Guide (L)
Paper Guide (R)
Paper Guide
Release Lever
Lock
Print Surface
Paper Top Edge
Release