Toshiba TEC B-419-GS10-QQ - Manual (Page 23)

2. PRINTER SETUP EO1-33030
2.10 Program Download
2-13
2.10 Program Download
2.10.1 Outline of Features
2.10.2 Install Program
Installation
This section provides step by step instructions on how to setup and
download the firmware to the B-419 printer, and to make adjustments to
the printer sensors. The firmware download and the sensor adjustments
will be made from a Personal Computer via the RS-232C interface.
The software for performing the program download will allow the
download of the Firmware (Application Program including Boot
Program, and Character Generator) from the provided FDK, allow
adjustments to printer sensor sensitivity, and allow the download of the
Printer Information. The software will be run on a standard PC and
communication to the B-419 printer will be via the RS-232C cable.
Firmware Download - The Application Program, and Character
Generator are installed into the B-419 printer's Flash memory prior to
being shipped to the customer. However, if specifications should change
at a later date, this software will allow downloading firmware updates to
the B-419 printer.
Sensor Adjustment - The various sensors within the printer have been
set at the factory before shipping. However, it may become necessary to
make adjustments to the sensitivity of one or more of these sensors to
compensate for factors such as different label backing paper thickness,
opaqueness, etc. These adjustments can be made from a PC
communicating with the B-419 printer via the RS-232C interface.
Printer Information Registration - This portion of the software allows
you to download printer information from a standard PC to the printer's
memory. The printer information consists of the model name and printer
type. The printer will operate according to the selection of printer model
and printer type. These data will print out on diagnostic labels issued
from the printer.
Test Print - This portion of the software allows you to perform a test
print from a PC.
Before you can communicate from your PC to the B-419 printer, you
must first copy the "Install Program for B-419" from the three FDKs
provided to the hard disk of your PC.
SETUP DISK (1/3)
Install Program for B-419 Standard
15th June 2001
FMRM0064201
V001.000
Copyright ©2001
TOSHIBA TEC CORPORATION
All Rights Reserved