Thermador MES301HS - Manual (Page 20)

20
You can change the time when the food will be done. The appliance starts
automatically and turns off at the preferred End Time.
If the appliance is set to 12Ćhour mode, the End Time can only be delayed for up to
12 hours (see Basic Settings).
CAUTION: Ą To maintain food safety, do not leave food in the oven for more
than one hour before and after cooking.
Some programs do not allow the End Time to be changed.
The time required for preheating when using steam must be considered when
setting the Cook Time. The set End Time can be delayed to make up for the time
required for preheating.
The example is shown in the illustration:
It is 9:30 a.m. The food takes 45 minutes to cook, but should not be ready until
12:45 p.m.
Requirement:
The set mode has not started. A Cook Time has been set.
1. Press TIMER/CLOCK repeatedly until the arrow appears after the End Time
symbol yO.
The bars in the display indicate that the End Time has not been changed.
2. Use the settings dial to set the End Time to a later time.
3. Press START/STOP to confirm.
The setting is accepted. The appliance is in delayed mode. The End Time yO is
displayed.
Operation starts automatically at the correct time. In the example, operation starts at
12:00 p.m. The running Cook Time xO then appears in the display.
The End Time can be adjusted as long as the appliance is in delayed mode. To do
this, use TIMER/CLOCK to switch to End Time yO and use the settings dial to
adjust the End Time.
The End Time can be adjusted as long as the appliance is in delayed mode. To do
this, use TIMER/CLOCK to switch to End Time yO and turn the settings dial to the
left until --:-- appears. Cook Time starts immediately.
Changing the End Time
ř
Delaying the End Time
Adjusting the End Time
Canceling the End Time