Thermador MES301HS - Manual (Page 14)

14
The 9 display flashes when the water tank is empty. A beep sounds and operation
is stopped.
1. Carefully open the oven door. Steam will escape from inside.
2. Remove the water tank, fill it and slide it back in.
3. Press START/STOP.
The temperature at which the water will boil depends on the air pressure. During
calibration, the appliance is adjusted to the pressure conditions in the area where
it has been installed. This takes place automatically the first time steam is used at
210 °F (100 °C). More steam than usual will be produced during calibration.
To ensure that the appliance will automatically adjust to the new location, reset the
appliance to its factory settings (see Basic Settings).
Getting Started
This section covers the following:
D Setting the clock after plugging in the appliance
D Changing the water hardness level, if necessary
D Cleaning the appliance prior to initial use
After plugging in the appliance, ‹‹:‹‹ flashes on the display.
Turn the settings dial to set the clock to the current time. The setting is automatically
accepted after a few seconds.
1. Press TIMER/CLOCK repeatedly until the arrow appears after the clock
symbol 0 O.
2. Use the settings dial to set the current time.
3. Press TIMER/CLOCK to confirm.
Descale the appliance using Decalcify mode at regular intervals. This can prevent
damage to the appliance.
The appliance automatically informs when descaling is required. The factory setting
is water hardness level II. Change the setting if your water is softer or harder.
Check the water hardness using the test strips provided or ask your water utility
company.
9 Flashes
Automatic Calibration
After Moving
Setting the Clock
Changing the Time
Adjusting the Water
Hardness Level
Checking Water Hardness