Thermador MES301HS - Manual (Page 15)

15
Descaling is not required if you only use softened water. In this case, change the
water hardness level to softened "-".
1. Press and hold ON/OFF until the appliance turns on.
2. Press and hold INFO for approximately 4 seconds.
The initial basic setting ’‹‚ appears in the display.
3. Press INFO repeatedly until ’‹ˆ (water hardness level) appears in the display.
4. Use the dial to change the water hardness level.
Options
-
softened
‚ 1Ćsoft I
ƒ 2Ćaverage II
„ 3Ćhard III
4Ćvery hard IV
5. Press and hold INFO for approximately 4 seconds.
The change is stored.
Before initial use, heat up the appliance once while empty and clean the
accessories.
1. Fill and slide in the water tank.
2. Press and hold ON/OFF to turn the appliance on.
OVEN MODE lights up on the display.
3. Use the settings dial to set the oven mode to Steam Á .
4. Press START/STOP to turn on the appliance.
The appliance automatically heats up to 210 °F (100 °C) and turns off after
20 minutes. A beep sounds.
5. Press and hold ON/OFF until the appliance turns off.
Leave the door open a crack until the appliance has cooled.
Clean the accessories thoroughly with soapy water and a cloth before initial use.
Softened Water
Changing the Water Hardness Level
Cleaning
Heating Up the Appliance
Cleaning Accessories Before Use