Onkyo DR-90 - Manual (Page 28)

28
Playing the Connected Source
This section shows you how to play the sources
connected to the DVD Receiver.
You may need to see “Connecting to a TV”
on page 10 and “Connecting to Audio/Video
Equipment” on page 11 while following the
steps in this section.
D O W N U P
DISPLAY TUNING SPEAKER SETUP CH LEVEL ENTER PHONES
OFF ON
STANDBY/ ON
MODE
FM MUTE PRESET MEMORY
DOWN UP STOP PAUSE PLAY OPEN/CLOSE
TREBLE BASS
PRESET / MODE ADJ
MASTER VOLUME
POWER Re - EQ SURROUND MODE
LATE NIGHT INPUT SELECTOR
STANDBY
F M A M T V TAPE/MD
VIDEO 1 VIDEO 2 DVD
1
SENDING/
LEARNED DVD RECEIVER TV
LEVEL SETUP
TITLE MENU SURROUND MODE
DVD TV ENTER
RETURN
AUDIO
SEARCH
ANGLE ZOOM
CLEAR
TUNER
SETUP VIDEO 1 TAPE
VIDEO 2
INPUT SELECTOR
OPEN/ CLOSE
DIMMER SLEEP DISPLAY ON STANDBY
POWER
SUBTITLE
CH SEL
LEVEL TEST TONE
2 3 1
5 6 4
8 9 7
0 +10
MUTING
RANDOM
REPEAT A-B MEMORY VOLUME
PRESET
PAUSE FF
PLAY DOWN
STOP SLOW
UP
FR
CHANNEL TV/ VCR
POWER
REMOTE CONTROLLER RC-399M
TUNER
1
1
2
TV
TAPE VIDEO 1
VIDEO 2
T V
VIDEO 2
1
2
TAPE/MD
VIDEO 1
Operating with the remote controller
Press one of the INPUT SELECTOR
buttons below to select the input
source:
• TV
• TAPE
• VIDEO 1
• VIDEO 2
When TV is selected
Start playing the selected source.
Operating with the DVD Receiver
Press one of the INPUT SELECTOR
buttons below to select the input
source:
• TV
• TAPE/MD
• VIDEO 1
• VIDEO 2
Start playing the selected source.
About digital sound
If the equipment is digitally connected to the DVD Receiver,
the sound from the digital input will automatically be selected
and reproduced instead of the analog sound as explained
below.
• When the VIDEO 1 source is selected, the digital sound
from the DIGITAL INPUT OPTICAL VIDEO 1 connector is
reproduced.
• When the VIDEO 2 source is selected, the digital sound
from the DIGITAL INPUT COAXIAL VIDEO 2 connector is
reproduced.
When the digital sound is reproduced, the PCM DIGITAL (2
channel digital stereo), DOLBY DIGITAL, or DTS indicator
lights up according to the received sound system in the DVD
Receiver’s display.
PCM DIGITAL DOLBY DIGITAL DTS
Enjoying the picture with the sound of
another source
The picture from the last selected VIDEO IN jack (VIDEO 1
or VIDEO 2) continues to be output through the MONITOR
OUT jack even if you change to another audio source.
Therefore, if you select VIDEO 1 or VIDEO 2 first, then select
TAPE/MD, FM, AM, or TV, you can enjoy the VIDEO 1 or
VIDEO 2 picture and the sound from TAPE/MD, FM, AM, or
TV at the same time.
Various Functions While Playing the
Connected Source
To use the following functions, see page 29.
• Adjusting the volume
• Adjusting the tone
• Dimming the DVD Receiver’s display
• Listening through headphones
• Using the Sleep Timer
• Muting the sound
Enjoying the Sound Effects While
Playing the Connected Source
See page 30.