Onkyo DR-90 - Manual (Page 26)

26
1
2
1
2
Listening to the Radio
FM MUTE
D O W N U P
DISPLAY TUNING SPEAKER SETUP CH LEVEL ENTER PHONES
OFF ON
STANDBY/ ON
MODE
FM MUTE PRESET MEMORY
DOWN UP STOP PAUSE PLAY OPEN/CLOSE
TREBLE BASS
PRESET / MODE ADJ
MASTER VOLUME
POWER Re - EQ SURROUND MODE
LATE NIGHT INPUT SELECTOR
STANDBY
F M A M T V TAPE/MD
VIDEO 1 VIDEO 2 DVD
2 1
D O W N U P
DISPLAY TUNING SPEAKER SETUP CH LEVEL ENTER PHONES
OFF ON
STANDBY/ ON
MODE
FM MUTE PRESET MEMORY
DOWN UP STOP PAUSE PLAY OPEN/CLOSE
TREBLE BASS
PRESET / MODE ADJ
MASTER VOLUME
POWER Re - EQ SURROUND MODE
LATE NIGHT INPUT SELECTOR
STANDBY
F M A M T V TAPE/MD
VIDEO 1 VIDEO 2 DVD
4 2 3,5
F M
A M
TUNING
Tuning Manually
You can tune manually only with the buttons on the DVD
Receiver.
Press FM or AM to select the band.
Press TUNING / to change the
frequency.
• The frequency changes in 50 kHz steps
in FM and 10 kHz in AM each time you
press TUNING
/ .
• In FM, if this button is held
continuously for more than 0.5
seconds, the frequencies are scanned
automatically–FM auto tuning mode.
When a broadcast is received,
scanning stops.
Tuning in a weak frequency
(only for FM stations)
When you tune in a stereo FM station, the FM STEREO
indicator lights up if the signal is sufficiently strong.
If the signal is weak,
you may not be able
to tune to the station.
In this case, tune in
as follows.
Press FM MUTE.
The FM MUTE indicator turns off. At this
time, the station will be in mono and
interstation noise will be heard.
Select the station to which you want to listen.
FM MUTE
PRESET /
MODE ADJ
PRESET
MEMORY
3
ENTER
4
5
ENTER
There are two ways to select radio stations: one is manual tuning and
the other is presetting radio stations then selecting the preset channels.
Presetting Radio Stations
• You can preset up to 30 stations.
• You can preset radio stations only with the buttons on the
DVD Receiver.
Tune in the radio station you wish
to preset (see steps on the left).
Press PRESET MEMORY.
“PRESET IN” appears in the DVD
Receiver’s display.
While “PRESET IN” is lit in the
display, press ENTER.
The MEMORY indicator lights up in the
display.
While the MEMORY indicator is lit in
the display, press PRESET
/ to
select the channel number to which
you wish to register the radio
station.
Press ENTER.
The radio station is registered to the
preset channel.
To register another preset station, repeat
steps 1 to 5.