Omega Engineering CN9400 - Manual (Page 23)

Function List
Sensor burn-out/break protection
Caution: Settings affect fail safe state.
SP1 SP2
[uP.SC] Upscale Upscale
dn.SC Downscale Downscale
1u.2d Upscale Downscale
1d.2u Downscale Upscale
Select output modes: Direct/Reverse
Caution: Settings affect fail safe state.
SP1 SP2
[1r.2d] Reverse Direct
1d.2d Direct Direct
1r.2r Reverse Reverse
1d.2r Direct Reverse
Select Reverse on SP1 for heating and Direct for
cooling applications.
19
LEVEL 3
OUTPUT CONFIGURATION
Note: ‘Read only’ after initial configuration. rSET ALL full reset to
factory settings required to change subsequently.
F unction Options [Factory settings] shown in brackets
[nonE] rLY SSd rLY1 rLY2 SSd1
Select SP1 output device
[nonE] SSd rLY rLY2 rLY1 SSd2
Read SP2 output device
(read only)
Dual Relay and Dual SSd output options Models CN9411
and CN9422 are factory set. See page 22
Note: (when in initial configuration only)
Hold ✱ and ▲ or ▼ for 10 seconds to move to or from
output devices in shaded portion.
SP1.D
BURN
REU.D SP1.D
SP2.D