Onkyo HTC-V10X - Manual (Page 64)

64
Operating the TV from Remote Controller
By programming the TV’s remote control code, you can use the RC-568S remote controller to
operate your TV.
■ Programming a TV remote control code
MEMORY
RC-568S
3
4
2
1
Find the three-digit number for the
brand name of the component you
want to operate in the table on the
next page.
2
While pressing and holding down
STANDBY/ON, press ENTER, then
release both buttons.
3
Enter the three-digit remote control
code.
Press the number buttons to enter the code
within 30 seconds. This time, you do not
press 10 KEY. Use only the number but-
tons.
4
Make sure that the remote control
code has been programmed cor-
rectly.
Press the remote controller buttons that
control the TV to see if TV responds cor-
rectly.
Release the buttons.
You can use these
buttons to control
your TV.
HTC-V10X_En.book Page 64 Wednesday, July 21, 2004 2:49 PM