Onkyo HTC-V10X - Manual (Page 55)

55
Using the Timer Functions —Continued
■
Cancelling the timer programming operation
Press TIMER.
MULTI JOG
PUSH TO ENTER
MULTI JOG
PUSH TO ENTER
MULTI JOG
PUSH TO ENTER
MULTI JOG
PUSH TO ENTER
STANDBY / ON
STANDBY
Rotate MULTI JOG to specify the timer
On time.
When the unit displays the desired time, press
MULTI JOG.
Notes
• When you set the On time, the Off time is
automatically set to an hour later.
• If an MD recorder is programmed to start
recording by a timer, the first few seconds of
the signal may not be recorded. Program the
On time to a value that is about one minute
earlier than the desired On time.
Rotate MULTI JOG to set the timer Off
time.
When the unit displays the desired time, press
MULTI JOG.
Turn off the power to place the unit in
Standby mode.
Press STANDBY to place the unit in Standby
mode.
• During timer recording, the unit is muted
and the subwoofer (SWA-V10X) is not
turned on. If you wish to audition the sound
during recording, press MUTING to cancel
mute mode. The subwoofer is turned on and
you will be able to hear the sound.
5
6
Specifying the On time
7
Setting the Off time
Placing the unit in Standby
mode.
Notes:
• If you wish to record FM or AM analog signals to an MD recorder, be sure to select
“Analog In” for the MD’s recording input source.
• Unless the unit is in Standby mode, the timer will not work at the programmed time. Be
sure to place the unit in Standby mode by pressing STANDBY so that the timer will
work.
HTC-V10X_En.book Page 55 Wednesday, July 21, 2004 2:49 PM