Onkyo HTC-V10X - Manual (Page 58)

58
Recording
The copyright laws prohibit using your recordings without consent of the copyright owner,
except for the purpose of your personal entertainment.
The remote controller buttons used in the following step are illustrated inside a gray rectangle
(
).
SW LV L CTRL STANDBY / ON
STANDBY
INPUT
SURROUND
MEMORY TIMER
CLEAR PHONES
MULTI JOG
AV CONTROLLER
MASTER VOLUME DTS PCM DIGITAL DSP STEREO(GRN )
MULTI IN(RED )
PR- 155X
PUSH TO ENTER
PL 1
1
INPUT
1
2
Press INPUT on the PR-155X or the
remote controller to select the record-
ing source component.
3
PR-155X
Prepare the recording component.
• Place the recording component in record standby mode.
• Adjust the recording level on the recording component.
• Refer to your recorder’s instruction manual for information on signal-synchronized
recording (i.e., synchronized recording using input signal detection), or information
on recording via its analog inputs.
Start recording.
Start playing the source component selected in Step 1.
Notes:
• For digital recording, you need to connect the digital output of the source component
to the digital input of the recording component.
• Do not change the input selection during recording. Otherwise, the recording cannot
be made correctly.
• Set the input source (page 32) to perform Synchro recording, or other system record-
ing using Onkyo components that feature the connector.
• You cannot perform digital CD Synchro recording from the DV-S155X to an Onkyo
MD recorder.
HTC-V10X_En.book Page 58 Wednesday, July 21, 2004 2:49 PM