Onkyo HTC-V10X - Manual (Page 40)

40
Enjoying the Surround Sound —Continued
■
Adjusting the subwoofer level
You can adjust the SWA-V10X subwoofer volume level using the PR-155X or the remote con-
troller. This setting is cancelled when the PR-155X enters standby mode.
The remote controller buttons used in the following step are illustrated inside a gray rectangle
(
).
Using the DIMMER function
SW LV L CTRL STANDBY / ON
STANDBY
INPUT
SURROUND
MEMORY TIMER
CLEAR PHONES
MULTI JOG
AV CONTROLLER
MASTER VOLUME DTS PCM DIGITAL DSP STEREO(GRN )
MULTI IN(RED )
PR- 155X
PUSH TO ENTER
PL
SW LVL CTRL
SW LVL CTRL
DIMMER
▲/▼
Adjust the subwoofer level by pressing SW LVL CTRL.
Each press of the button changes the volume level in three steps as
follows:
Alternatively, press
▲/▼ on the remote controller or rotate MULTI
JOG on the PR-155X to adjust the level in the range of +12 to –30.
• If you set the subwoofer level to –30, the volume level of the sub-
woofer will be minimal.
0 +3 (default setting) +6
SW LVL CTRL
PR-155X
Press DIMMER on the remote controller to change the display
brightness.
Each press of the button changes the display brightness as follows:
Normal Dim Very Dim
HTC-V10X_En.book Page 40 Wednesday, July 21, 2004 2:49 PM