Onkyo HTC-V10X - Manual (Page 36)

36
Enjoying the Surround Sound —Continued
■
Selecting a surround mode
The remote controller buttons used in the following step are illustrated inside a gray rectangle
(
).
SW LV L CTRL STANDBY / ON
STANDBY
INPUT
SURROUND
MEMORY TIMER
CLEAR PHONES
MULTI JOG
AV CONTROLLER
MASTER VOLUME DTS PCM DIGITAL DSP STEREO(GRN )
MULTI IN(RED )
PR- 155X
PUSH TO ENTER
PL
3
1
1
3
Input signal indicator Surround mode indicator
DTS PCM DIGITAL DSP STEREO (GRN )
MULTI IN (RED )
PL
SURROUND
SURROUND
1
2
Press INPUT on the PR-155X or remote
controller to select a component to play
back.
The unit displays the playback component, and a
surround indicator shows the current Surround
mode.
Play the selected component.
Press SURROUND on the PR-155X or
remote controller to select a Surround
mode.
Repeatedly pressing SURROUND switches the
Surround mode. Available modes vary with the
type of input signal. (See the next page.)
Playback component Volume
3
INPUT
PR-155X
Digital input signal (orange)
(No Surround indicator
lights up for analog inputs.)
Selected Surround
mode (green)
Example: Listening to Dolby Digital audio in Stereo
Tips:
When you listen to Dolby Digital audio with the DOLBY D listening mode, or a DTS
source with the DTS listening mode, no Surround mode indicator will light up.
You cannot change Surround mode during multi channel audio playback.
HTC-V10X_En.book Page 36 Wednesday, July 21, 2004 2:49 PM