Onkyo HTC-V10X - Manual (Page 3)

3
Precautions
1. Recording Copyright —Unless it’s for per-
sonal use only, recording copyrighted material
is illegal without the permission of the copy-
right holder.
2. AC Fuse —The AC fuse inside the HTC-V10X
is not user-serviceable. If you cannot turn on
the HTC-V10X, contact your Onkyo dealer.
3. Care —Occasionally you should dust the
HTC-V10X all over with a soft cloth. For stub-
born stains, use a soft cloth dampened with a
weak solution of mild detergent and water. Dry
the HTC-V10X immediately afterwards with a
clean cloth. Don’t use abrasive cloths, thinners,
alcohol, or other chemical solvents, because
they may damage the finish or remove the
panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING SEC-
TION CAREFULLY.
AC outlet voltages vary from country to coun-
try. Make sure that the voltage in your area
meets the voltage requirements printed on the
HTC-V10X’s rear panel (e.g., AC 230 V, 50 Hz
or AC 120 V, 60 Hz).
Memory backup
The HTC-V10X uses a battery-less memory
backup system in order to retain radio presets and
other settings when it’s unplugged or in the case of
a power failure. Although no batteries are required,
the HTC-V10X must be plugged into an AC outlet
in order to charge the backup system.
Once it has been charged, the HTC-V10X will
retain the settings for several weeks, although this
depends on the environment and will be shorter in
humid climates.
However, the clock and timer settings are can-
celled.
For British models
Replacement and mounting of an AC plug on the
power supply cord of this unit should be performed
only by qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accor-
dance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be con-
nected to the terminal which is marked with the let-
ter L or coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the
fuse needs to be replaced, the replacement fuse
must approved by ASTA or BSI to BS1362 and
have the same ampere rating as that indicated on
the plug. Check for the ASTA mark or the BSI
mark on the body of the fuse.
IF THE FITTED MOULDED PLUG IS UNSUIT-
ABLE FOR THE SOCKET OUTLET IN YOUR
HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY. THERE IS A DANGER
OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13
AMPERE SOCKET.
If in any doubt, consult a qualified electrician.
For European Models
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
I. MORI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
HTC-V10X_En.book Page 3 Wednesday, July 21, 2004 2:49 PM