Onkyo HTC-V10X - Manual (Page 42)

42
Listening to the Radio —Continued
■
Using RDS (European models only)
When tuned into an RDS (Radio Data System) station that’s broadcasting PS (Program Service
Name) information, the RDS indicator lights up and the name of the station appears on the dis-
play.
Only European models support RDS, and only in areas where RDS is used.
■
Switching between Auto and Mono mode
MULTI JOG
PUSH TO ENTER
MULTI JOG
PUSH TO ENTER
Rotate MULTI JOG to select AUTO
PR.
Press MULTI JOG to start Auto Pre-
set Memory.
flashes. The unit displays the fre-
quency value and starts searching for the
next available station.
• Up to 20 stations are automatically pro-
grammed to preset numbers, in order,
starting with the lowest frequency.
Note:
All FM stations previously stored in mem-
ory will be replaced with the new Auto Pre-
set Memory stations.
3
4
To receive FM stereo broadcast stations, press MODE
on the remote controller to turn on the “AUTO” indica-
tor.
• When the unit receives an FM stereo broadcast in
Auto mode, the ST (stereo) indicator lights up.
Tips
• At a frequency with weak radio signals or with a lot
of noise, the ST indicator does not light up.
If the ST (stereo) indicator is flashing, press MODE
again to turn off the AUTO indicator and switch to
monaural reception. In this way, you can reduce
noise and intermission.
• If the reception is poor, adjust the direction of the
indoor antenna or move the antenna near a window
or find a location with strong signals. If the situation
does not improve, install an outdoor antenna.
FM STEREO
indicator lights up
AUTO
indicator
HTC-V10X_En.book Page 42 Wednesday, July 21, 2004 2:49 PM