Onkyo PR-SC885 - Manual (Page 95)

95
Advanced Setup —Continued
5 Use the Up and Down [ ]/[ ]
buttons to select “Front,” and
then use the Left and Right
[
]/[ ] buttons to select a
crossover frequency.
Note:
• Fixed at Full Band if Subwoofer
(step 4) is set to No.
6 Use the Up and Down [ ]/[ ]
buttons to select “Center,” and
then use the Left and Right
[
]/[ ] buttons to select a
crossover frequency.
If no center speaker is connected, select
None.
Note:
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.
7 Use the Up and Down [ ]/[ ]
buttons to select “Surround,” and
then use the Left and Right
[
]/[ ] buttons to select a
crossover frequency.
If no surround left and right speakers
are connected, select None.
Note:
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.
8 Use the Up and Down [ ]/[ ]
buttons to select “Surr Back,”
and then use the Left and Right
[
]/[ ] buttons to select a
crossover frequency.
If no surround back speakers are con-
nected, select None.
Notes:
• Cannot be set if Speaker Type is set
to Bi-Amp (page 44) or Surround is
set to None (step 7).
• Cannot select Full Band if Surround
(step 7) is set to anything other than
Full Band.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
9 Use the Up and Down [ ]/[ ]
buttons to select “Surr Back Ch,”
and then use the Left and Right
[
]/[ ] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Note:
• Cannot be set if Speaker Type is set
to Bi-Amp (page 44) or SurrBack is
set to None (step 8).
Continue with step 10 on the next page.
ENTER
ENTER