Onkyo PR-SC885 - Manual (Page 117)

117
Controlling Other Components —Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV con-
troller, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
, use
the following remote control codes:
• [DVD] REMOTE MODE button
5001: Onkyo DVD player without (default)
• [CD] REMOTE MODE button
6001: Onkyo CD player without (default)
• [MD] REMOTE MODE button
6007: Onkyo MD recorder without
• [CDR] REMOTE MODE button
6005: Onkyo CD recorder without
• [DOCK] REMOTE MODE button
6003: Onkyo DS-A2 RI Dock without (default)
Note:
• If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote oper-
ation to work properly, you must set the Input Display
to MD or CDR, respectively (see page 49).
Resetting the Remote Mode Buttons
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
1 Make sure the Onkyo component is con-
nected with an
cable and an analog
audio cable (RCA).
See page 42 for details.
2 Enter the appropriate remote control code
to the REMOTE MODE button.
• [DVD] REMOTE MODE button
5002: Onkyo DVD player with
• [CD] REMOTE MODE button
6002: Onkyo CD player with
• [MD] REMOTE MODE button
6008: Onkyo MD recorder with
• [CDR] REMOTE MODE button
6006: Onkyo CD recorder with
• [DOCK] REMOTE MODE button
6004: Onkyo DS-A1 RI Dock with
See the previous page for how to enter remote
control codes.
3 Press the REMOTE MODE button, point
the remote controller at the AV controller,
and operate the component.
1 While holding down the REMOTE
MODE button that you want to
reset, press the TV [
] button.
The Remote indicator flashes three
times.
2 Press the REMOTE MODE button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers, respectively. When these buttons
are reset, the preprogrammed codes are
restored.
Resetting the Remote Controller
1 While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [STANDBY] button.
The Remote indicator flashes five
times.
2 Press the [RECEIVER] REMOTE
MODE button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
CDR/MD
SAT
REMOTE MODE
TV
DOCK
VCR
CABLE
DVD
CD
CDR/MD
SAT
REMOTE MODE
TV
DOCK
VCR
CABLE
DVD
CD
RECEIVER
STANDBY
RECEIVER