First time setup —continued – Onkyo PR-SC885 User Manual
Page 53
53
First Time Setup
—Continued
1
Turn on the AV controller and the
connected TV.
On the TV, select the input to which the
AV controller is connected.
2
Place the setup microphone at
the 1st measurement position,
and connect it to the SETUP MIC
jack.
Notes:
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD movie.
• Positioning the microphone close to
where your ears would normally be
will provide the best results. You can
set the height of the microphone by
using a tripod or level table.
3
Press [ENTER].
A test tone is output by each speaker in
turn, as Audyssey MultEQ XT deter-
mines which speakers are connected.
This takes a few minutes.
Note:
• If any extraneous noise is picked up
by the microphone, the automatic
setup may not work correctly, so
keep quiet.
SETUP MIC
Auto Speaker Setup
Please place microphone at center
of listening area at ear height.
Push Enter : Next
AUDYSSEY
ENTER
Auto Speaker Setup
Do not unplug microphone.
Please keep quiet.
Now Measuring...
AUDYSSEY
4
The speaker detect results
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [
]/[
] but-
tons to select Next, and then
press [ENTER].
The options are:
Next:
Proceed to the next step.
Retry:
Return to step 2 and try again.
Cancel:
Cancel the automatic speaker
setup.
5
The following screen appears.
Place the setup microphone at
the next position (see page 52),
and then press [ENTER].
Audyssey MultEQ XT performs more
measurements. This takes a few min-
utes.
6
When prompted, place the setup
microphone at the next position,
and repeat step 5.
ENTER
ENTER
Auto Speaker Setup
-----SP Detect Result-----
FL : Yes FR : Yes
SL : Yes SR : Yes
SBL : Yes SBR : Yes
C : No SW : Yes
Next
Retry
Cancel
AUDYSSEY
ENTER
Auto Speaker Setup
Please place microphone at
2nd Position at ear height.
Push Enter : Next
AUDYSSEY
Auto Speaker Setup
Do not unplug microphone.
Please keep quiet.
Now Measuring...
AUDYSSEY