Onkyo PR-SC885 - Manual (Page 44)

44
First Time Setup
This section explains the settings that you need to make before using the AV controller for the very first time.
If you’ve fed your front speakers from the FRONT L/R
and SURR BACK L/R outputs for bi-amping, you must
change the Speaker Type setting. For hookup informa-
tion, see “Bi-amping the Front Speakers” on page 23.
Notes:
• When bi-amping is used, the AV controller is able to
feed up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Note:
• This procedure can also be performed on the AV con-
troller by using its [SETUP], [ENTER], and arrow
buttons.
Speaker Settings
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
INPUT SELECTOR
DISPLAY MUTING
GU IDE EXI T
PREV
CH
DIMMER
CDR/MD
SAT TAPE/AMP
SLEEP
MACRO
REMOTE MODE
--/--- 10 11 12
TV CH
TV VOL
PLAYLIST RANDOM
AUX 1 AUX 2 GAME/TV
D. TUN
CD TUNER TAPE
PHONO
REC
ENTER
TO P M ENU MEN U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE DOCK
DVD
RECEIVER
CD
-
1 2 3 ZONE 3
ZONE 2
+
-
+10 0 CLEAR
4 5 6
7 8 9
SE TUP RET UR N
2, 3 2–5
1
1, 6
If you change these settings, you must run the auto-
matic speaker setup again (see page 52).
RECEIVER
SE
TUP
ENTER
ENTER
3 Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker Set-
tings,” and then press [ENTER].
The Speaker Settings menu appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “Speaker Type,”
and use the Left and Right
[
]/[ ] buttons to select:
Normal: Select this if you’ve con-
nected your front speakers
normally.
Bi-Amp: Select this if you’ve con-
nected your front speakers for
bi-amped operation.
5 Press the [SETUP] button.
Setup closes.
ENTER
ENTER
2-1.Speaker Settings
Speakers Type Normal
ENTER
SE
TUP