Runco LIGHTSTYLE LS-10D User Manual
Ls-10d
Table of contents
Document Outline
- RuncoCare™ Standard Two Year Limited Warranty
- Important Safety Instructions
- Compliance Information
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Optional Anamorphic Lens Mount
- 3.5 Mounting the LS-10d
- 3.6 Connections to the LS-10d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the LS-10d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-volt Trigger Outputs to External Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.7 Turning on the Power
- 3.8 Primary Lens Adjustments
- 3.9 Adjusting the Picture Orientation
- 3.10 Adjusting the Image Geometry
- 3.11 Installing and Adjusting the Anamorphic Lens
- 4. Operation
- 4.1 Using the On-Screen Menus
- Figure 4-1 . DHD Controller OSD Menu Structure for LS-10d
- Main Menu
- Input Source
- Aspect Ratio
- Picture
- Input Position
- Memory Presets
- Sleep Timer
- Information
- Calibration
- Service
- 4.1 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. External Control
- 7. Specifications