Runco LIGHTSTYLE LS-10D - Manual (Page 84)

Operation
68 Runco LS-10d Installation/Operation Manual
PRE
L
IMINAR
Y
• Error Notification: To have the DHD Controller send a message to the destination
e-mail address when a “DHD Error” or “Display Error” occurs, select Error
Notification from the E-Mail Notification menu and set it to On.
• Error Notification to Runco: To have the DHD Controller send an e-mail message
to Runco Customer Support when a “DHD Error” or “Display Error” occurs, select
Error Notification to Runco from the E-Mail Notification menu and set it to On.
• Periodic Service Notification: You can have the the DHD Controller send periodic
reminders via e-mail to perform regular maintenance tasks. To do this:
1. Select Periodic Service Notification from the E-Mail Notification menu.
2. Highlight Enable and press ENTER.
3. Highlight On and press ENTER.
4. Press MENU.
5. Highlight Timer and press ENTER.
6. Press or to set the notification interval in months. The range is from 1 to
255 inclusive; the default is 12 months.
7. Press MENU.
• Lamp Life Notification: To have the DHD Controller send a message to the
destination e-mail address when the lamp hour counter reaches a certain threshold,
select Lamp Life Notification from the E-Mail Notification menu. Then:
1. Highlight Enable and press ENTER.
2. Highlight On and press ENTER.
3. Press MENU.
4. Highlight Lamp Hours and press ENTER.
5. Press or to set the notification threshold in hours. The range is from 100 to
10,000 hours; the default is 1,000 hours.
6. Press MENU.
• Customer Information: Select Customer Information from the E-Mail Notification
menu to supply this information to the DHD Controller, which includes it in all e-mail
notification messages. Six lines (up to 30 characters per line) of text are provided;
use them however you wish.
1. Press or repeatedly to select a line of text to edit.
2. Press ENTER.
3. Press or repeatedly to set the highlighted character.
4. Press (or ) to select the next (or previous) character. Use the and
buttons to change it.
5. Press ENTER when you have finished editing that line of text.
6. Repeat Steps 1 through 5 for each line of text you want to edit.
7. Press MENU when you have finished entering customer information.
• E-Mail Calibration Data: To have the DHD Controller collect all calibration data,
attach it to a message and send it to the destination e-mail address, select E-Mail
Calibration Data from the E-Mail Notification menu. To confirm this action, select Yes
and press ENTER.
To cancel and return to the previous menu, select No.