Runco LIGHTSTYLE LS-10D - Manual (Page 36)

Installation
20 Runco LS-10d Installation/Operation Manual
PRE
L
IMINAR
Y
Vertical and Horizontal
Position
Proper placement of the projector relative to the screen will yield a rectangular,
perfectly-centered image that completely fills the screen.
Ideally, the projector should be positioned perpendicular to the screen and in such a way
that the lens center is aligned with either the top or bottom edge of the screen area, and
centered horizontally. See Figure 3-2.
Figure 3-2. Projector Placement
Vertical and Horizontal
Lens Shift
You can use the lens shift controls to center the image on the screen. Lens shift is
generally expressed as a percentage of the screen height or width, as shown in Figure 3-3
and Figure 3-4.
Figure 3-3. Vertical Lens Shift (EXAMPLE ONLY)
➤
Screen
Height
Projection Distance
Ceiling
x
Lens Center Lens Center
Ceiling Installation
Screen Height
Floor
Lens Center
Projection Distance
Floor Installation
Lens Center
x
➤
50% Height
Lens Shift
(0.5 x H)
100% Height
Lens Shift
(1.0 x H)
Screen Center
0%
Note: This is a general example of lens shift. Lenses vary in their shift capabilities. No particular
lens or projector is used in this example.