Runco LIGHTSTYLE LS-10D - Manual (Page 87)

Operation
Runco LS-10d Installation/Operation Manual 71
PRE
L
IMINAR
Y
Sync Threshold: Select Sync Threshold to adjust the threshold at which negative pulses
on the component video green/luma channel are interpreted to be sync pulses.
Sync Threshold adjustment is occasionally necessary when a DVD player or HDTV source
signal drops “below black” (for example, during scenes with explosions or when subtitles
are present) and causes the projector to temporarily lose sync. If the sync level from the
source is persistently too low, the display device won’t sync with the source at all.
The range is from 0 (approximately 60 millivolts (mV)) to 15 (approximately 300 mV).
HDMI: Select HDMI from the Service menu to set the following options affecting
communication between HDMI sources, the DHD Controller and the LS-10d.
• HDMI EDID Extension: Extended display identification data (EDID) is a data
structureprovided by a display device to describe its capabilities to a graphics card. It is
what enables a modern personal computer to know what kind of monitor is connected.
Some modern display devices provide more information via EDID than others, in the
form of “extensions.” Some computer graphics cards do recognize or properly interpret
this extended EDID information.
Select HDMI EDID Extension from the HDMI menu to specify whether or not the EDID
extensions from the display device are passed through to the sources connected to the
HDMI 1, HDMI 2, HDMI 3 or HDMI 4 inputs. By default, the extensions are on. Change
these settings only if HDMI EDID incompatibility issues arise.
• Audio Format: Select Audio Format from the HDMI menu to choose an option for
routing the audio signal from an HDMI source. With the LS-10d, the recommended
setting is HDMI Out (Audio Only). (This is the default setting.)
• CEC: This control chooses whether or not the DHD Controller responds to HDMI CEC
control messages from a disc player, set-top box or other HDMI source. It also enables
or disables CEC communication between the DHD Controller and projector.
The default (and recommended) setting is On. For more information about CEC, refer
to Using HDMI CEC Messages on page 84.
1. Setting CEC to Off prevents communication between the DHD
Controller and projector, and should be done only for
troubleshooting purposes.
2. The DHD Controller does not transmit HDMI CEC control
messages from the “HDMI Audio Out” connector.
Note