Information, Signal / system, Network – Runco LIGHTSTYLE LS-10D User Manual
Page 74: Field service / manufacturing, Calibration, Display color, Pre l iminar y
58
Runco LS-10d Installation/Operation Manual
PRE
L
Y
Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Network: Select Information from the Main Menu, then choose Network to display
information about the Ethernet network connection.
To enable network communication via Ethernet, refer to IP Configuration on page 66.
Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.
Use the Calibration menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
To recall the ISF Night or ISF Day settings, select “ISF Night” or “ISF Day” from the
Memory Presets menu (see page 56) or use the corresponding remote control buttons.
Display Color: Use the Display Color settings to adjust the color balance at the DHD
Controller output. These settings are saved independently for each input and display
mode.
• Gain: Use the Gain controls to correct color imbalances in the bright areas of the
image. A good way to do this is to use a test pattern consisting mostly of solid white
areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red (Pr),
green (Y) or blue (Pr), decrease the Gain for that color.
• Offset: Use the Offset controls to correct color imbalances in the dark areas of the
image. A good way to do this is to use a test pattern consisting mostly of dark gray
areas, such as a 30 IRE “window” pattern. If the gray areas contain traces of red (Pr),
green (Y) or blue (Pr), decrease the Offset for that color.
➤
Input Source
HDMI 1
Signal Format
1080p/60
Input Resolution
1920x1080
Vertical Freq
59.94 Hz
Horizontal Freq
67.500 kHz
Pixel Clock
148.500 MHz
Color Space
REC709
Sync Type
Separate
Memory Preset
ISF Night
Model
DHD4
Display Name
LS-10d
Output Resolution 1920x1080
Serial Number
00000000
Boot Version
4.0
Firmware Version
4.0
Micro Version
4.0
MAC Address
1A:2B:3C:4D:5E:6F
IP Address
192.168.0.150
Subnet Mask
255.255.0.0
Default Gateway 192.168.1.1
DHCP
Enabled
Network Status Connected
ISF Settings
➤
You must enter a passcode to access the Calibration menu.
Note