6 connections to the ls-10d and dhd controller, Connector panel access, Connections to the ls-10d and dhd controller – Runco LIGHTSTYLE LS-10D User Manual

Page 46: Pre l iminar y

Runco LS-10d Installation/Operation Manual

PRE

IMINAR

3.6
Connections to the
LS-10d and DHD
Controller

Proceed as follows to connect the DHD Controller to the LS-10d, your video sources,
external controller(s) – if present – and AC power.

When connecting your equipment:

• Turn off all equipment before making any connections.

• Use the correct signal cables for each source.

• For best performance and to minimize cable clutter, use high-quality cables that are

only as long as necessary to connect two devices. (Don’t use a 20-foot cable when a
6-foot cable will suffice.)

• Ensure that the cables are securely connected. Tighten the thumbscrews on

connectors that have them.

Connector Panel Access

Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.

Then, remove the rear compartment cover by
tilting it upward.

➤