Regency P48-2 - Manual (Page 30)

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace 30
BRICK PANELS INSTALLATION
1) Unhook the 2 spring loaded hooks from the bottom of the fl ush door
and lift the Flush Front off the unit.
2) Unwrap the brick pattern panels from the protective wrapping.
Note: The logs must not be in the unit.
a) Loosen the two screws from the bottom of the baffl e plate. Install
the bottom clips onto the baffl e plate (refer to Diagram 1).
Diagram 1
Bottom Clips
Diagram 2
Top Bracket
5) Place the top bracket onto the front edge of the top panel (refer to
Diagram 5).
6) Slide the top panel and bracket assembly carefully onto the baffl e
plate ensuring the panel is centered. Make sure the tabs of the top
bracket fi t into the baffl e openings (refer to Diagrams 6 & 7). The
back of the top brick panel sits on top of the bottom clips.
3) Insert the back brick panel fi rst by carefully slipping it between the
back wall of the fi rebox and the rear log bracket (refer to Diagram 2).
4) Put the side panels in next. Tilt them in towards the middle of the
fi rebox and put the bottom front corner in fi rst. Be very careful not
to scratch them on the fi rebox hardware. Place them fl at up against
the wall, they should fi t snugly against the top of the fi rebox (refer to
Diagrams 3 & 4).
Diagrams 3 & 4
IMPORTANT
Dangerous operating conditions may
occur if the panels are broken.
NOTE: If the bottom brick panel must be removed: Remove the
grate, then remove the Burner Tray. See "Removing
Valve" section.
Diagram 5
Tabs
Diagram 6
Diagram 7
INSTALLATION