Regency P48-2 - Manual (Page 29)

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace 29
INSTALLATION
28) Locate the ground lug at the receptical box,
left of the unit.
29) Connect one end of the supplied green
ground wire to the lug with the nut and
washer from the kit.
30) Install the 1/2" bushing to the heat
shield.
Ground
wire from
kit
32) Plug the DC spark generator wires to the
DC Sparker.
33) Connect the ground wire to the DC Sparker
mounting bracket.
35) Mount the heat shield to the DC Sparker.
Secure into place with the velcro, which is
provided in the kit.
Heat Shield
31) Run the other end of the ground wire and
DC spark generator wires through the
bushing on the heat shield.
37) Tie up the loose wire with the wire clip.
Chain
36) Find a location which is not too hot and
is easy to reach for changing the battery.
Note: It should be kept away from the
chain.
34) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker Box
will need to be replaced annually.
Battery
Compartment