Regency SEE THRU P121-NG - Manual (Page 27)

Regency P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace 27
Option 1:
REMOTE CONTROL
Can be used with Option 2 or 3
but not both.
Use the Regency Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1) Choose a convenient location on the wall to
install the receiver and the receptacle box
(protection from extreme heat is very im-
portant). Run wires from the fireplace to
that location. Use the Thermostat Wire Ta-
ble.
2) Connect the two wires to the gas valve.
See diagram below.
Option 2:
WALL SWITCH
Can be used with Option 1 or 3
but not both.
1) Run the supplied 4.5m of wire through the
back gas inlet opening. Be careful not to
damage wire.
Note: We recommend a maximum of
4.5m of wire but if you wish to go
with a longer run, use the Thermo-
stat Wire Table.
2) Connect the wire to the supplied wall switch
and install into the receptacle box.
CAUTION
Do not connect millivolt
wall switch wire to a 240V wire.
CAUTION
Do not connect millivolt remote
control wires to a 240V wire.
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
15.0 M.
10.0 M.
6.0 M.
3.6 M.
2.7 M.
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
Thermostat Wire Table
Option 3:
WALL THERMOSTAT
Can be used with Option 1 or 2
but not both.
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use the table below to determine the maximum
wire length.
Note: Preferable if the thermostat is in-
stalled on an interior wall.
Regency offers an optional programmable ther-
mostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
CAUTION
Do not connect millivolt
wall thermostat wires
to a 240V wire.
3) Install 3 AAA alkaline batteries in transmitter
and 4 AA alkaline batteries in the receiver.
Install the receiver and its cover in the wall.
Switch the remote receiver to "remote"
mode. The remote control is now ready for
operation.
INSTALLATION