Roland cakewalk A-800PRO - Manual (Page 40)

40
Using A-PRO Editor
If you want to edit a keyboard set, use the following procedure to load the keyboard
map data from the A-PRO, so that it can be edited.
fig.keyboardset1.eps
1 Use the [SPLIT]/[DUAL]/[LOWER]
buttons to select the keyboard set
that you want to edit.
fig.keyboardsetrecv.eps
2 Click [Receive].
3 In the confirmation box, click [Continue].
4 A reception progress dialog box will appear.
When the dialog box disappears, reception is complete.
If you want to use a keyboard set created in A-PRO Editor on the A-PRO keyboard,
proceed as follows to transmit it.
fig.keyboardset1.eps
1 Use the [SPLIT]/[DUAL]/[LOWER]
buttons to select the keyboard set
that you want to edit.
fig.keyboardsettrans.eps
2 Click [Transmit].
3 In the confirmation box, click [Continue].
4 A transmission progress dialog box will appear.
When the dialog box disappears, transmission is complete.
Using Keyboard Sets
Receiving a Keyboard Set Transmitting a Keyboard Set
A-300_500_800C_e.book 40 ページ ２０１０年２月２２日 月曜日 午後９時１３分