Roland BR-800 - Manual (Page 73)

Editing
Mastering
Using USB
Con
venient
Functions
Appendix
es
Quic
k Star
t
Getting Read
y
to Recor
d
Recor
ding/
Pla
ybac
k
Using Eff
ects
Using Rh
ythm
75
Using Insert Effects
SITAR SIM (Sitar Simulator)
This simulates the sound of the sitar.
OCTAVE
This adds a note one octave lower, creating a richer sound.
Because of the need to analyze the pitch, chords (two or
more sounds played simultaneously) cannot be played.
P SHIFTER
This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
Parameter/
Range
Explanation
TONE
-50–+50
This adjusts the tone.
The high end is boosted as the value in-
creases.
SENS (Sensitivity)
0–100
Adjusts the sensitivity of the sitar.
When it is set to a lower value, no effect of
the sitar is obtained with weaker picking,
while stronger picking produces the effect.
When it is set to a higher value, the effect of
the sitar can be obtained whether the pick-
ing is weak or strong.
DEPTH
0–100 This adjusts the amount of effect applied.
RESONANCE
0–100
This adjusts the undulation of the reso-
nance.
BUZZ
0–100
Adjusts the amount of characteristic buzz
produced by the “buzz bridge” when the
strings make contact with it.
E.LEVEL (Effect Level)
0–100 Adjust the volume of the sitar sound.
D.LEVEL (Direct Level)
0–100 Adjust the volume of the direct sound.
Parameter/
Range
Explanation
OCT LEVEL (Octave Level)
0–100
Adjusts the volume of the sound one octave
below.
D.LEVEL (Direct Level)
0–100 Adjusts the volume of the direct sound.
Parameter/
Range
Explanation
TYPE
Selects either manual pitch shifter “MANUAL” or pedal
pitch shifter “PEDAL.”
MANUAL This is a simple pitch shifter.
PEDAL
The effect will function as a pedal pitch
shifter.
The effect of the wah pedal can be obtained
by operating the Expression pedal.
For a detailed explanation, see “Using an
Expression Pedal” (p. 129).
MODE
Selection for the pitch shifter mode.
FAST,
MEDIUM
,
SLOW
The response is slower in the order of
FAST, MEDIUM and SLOW, but the mod-
ulation is lessened in the same order.
PITCH
-24–+24
Adjusts the amount of pitch shift (the
amount of interval) in semitone steps.
FINE
-50–+50
Make fine adjustments to the interval.
The amount of the change in the Fine 100 is
equivalent to that of the Pitch 1.
PRE DELAY
0ms–300ms
Adjusts the time from when the direct
sound is heard until the pitch shifted
sounds are inputted. Normally you can
leave this set at 0ms.
FBK (Feedback)
0–100
Adjusts the feedback amount of the pitch
shift sound.
LEVEL
0–100 Adjusts the volume of the pitch shifter
D.LEVEL (Direct Level)
0–100 Adjusts the volume of the direct sound.
BR800_e.book 75 ページ ２０１０年３月２日 火曜日 午後６時４０分