RAD Data comm BLW-04EX - Manual (Page 3)

C onsu lt t he deal er o r an experienced rad io/ TV technici an for hel p
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
Warnings: Wear an antistatic wrist strap to take other suitable measures to
prevent electrostatic discharge whenever handling the equipment.
CE Mark Warning
This is a Cl ass B product. In a domest ic environment, t his product may
cause radi o i nterference in whi ch case the user may be required to t ake
adequate measures.
BLW-04EX BLW-04EX
Trademarks
Copyright @2002 PLANEX COMMUNICATIONS INC.
Contents subject to change without prior notice.
Pci is a registered trademark of PLANEX COMMUNICATIONS INC.
All other trademarks belong to their respective proprietors.
Copyright Statement
No part of this publication may be reproduced in any form or by any means
or used to m ake any derivati ve s uch as t rans latio n, transformati on, or
adaptation without permission from PLANEX COMUNICATIONS INC.
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when t he eq ui pment is operated i n a comm erci al env iron ment . Thi s
equipment generates, uses, and can radi ate radio frequency energy and, if
not i nstall ed and used in acco rdance wi th thi s user's g uide, may cause
harmful in terferen ce t o rad io com mun icati ons . H o w e v e r, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from the one
which the receiver is connected to